Call (503) 354-4094 for a free walkthrough
Mikesell Construction
Finished kitchen with navy lower cabinets, white uppers, subway tile backsplash and hardwood floors

Project Spotlight

Kitchen remodel with hardwood floors

Boise, ID

navy and white cabinets

Two-tone

hardwood floors

Full level

with prep space

New island

This kitchen renovation in Boise started with a functional layout and dated finishes. The homeowners had lived with the kitchen long enough to know exactly what they wanted to change: more prep space, a place for people to gather that was not in the middle of the work area, and finishes that matched the direction they were taking the rest of the house. A new kitchen was the goal. What made the project larger than just a kitchen was the decision to run new hardwood floors from the kitchen through the entire main living area at the same time.

The original kitchen had standard oak cabinets, laminate countertops, a vinyl floor, and appliances that were past their best years. The layout itself was functional: the refrigerator was in the right place and the work triangle was reasonable. What did not work was the connection between the kitchen and the adjacent living area. A half wall at the edge of the kitchen created a separation that made both rooms feel smaller than they were. Removing that half wall opened both spaces and required building a proper header to carry the load above.

Demolition and what was behind the walls

Every kitchen renovation starts with tearing out what is there before you know what you are working with. The cabinets came out cleanly. The walls behind them showed some minor moisture staining near the sink base cabinet from a previous drain issue that had been repaired at some point, but the framing was sound. The subfloor was solid plywood in good condition throughout the kitchen, which matters when you are installing hardwood. A subfloor that moves or flexes telegraphs through the finished floor and causes problems with the installation over time.

The half wall removal revealed a doubled stud configuration that had been added at some point, likely when the original framer anticipated but did not install an opening. Removing it was straightforward once the existing configuration was understood. The new header was sized for the opening span and the load above, and the rough opening was framed cleanly before the drywall went back. The electrical that ran through that wall was rerouted and brought up to current code requirements before it was closed up.

Navy lower cabinets and white upper cabinets

The two-tone cabinet scheme was the homeowners' choice from the beginning and it was the right direction. Navy lower cabinets provide a visual anchor at the base of the kitchen. They ground the space without making it feel heavy because the upper cabinets are white, which keeps the room open and bright. The navy reads as deliberate and current without being trendy in a way that dates in five years. It is the kind of choice that holds up because it is rooted in contrast and proportion rather than a moment in kitchen design.

The cabinet boxes are full-overlay construction with soft-close hinges and undermount drawer slides throughout. The doors are a flat-panel shaker profile, which is the correct choice for this color and this home. An ornate raised panel profile would have fought with the boldness of the navy color. The shaker panel keeps the cabinets clean and lets the color do the work. Cabinet installation in a kitchen requires careful shimming and leveling: a cabinet that is a sixteenth of an inch out of level at one end shows at the face frame joint, and that error compounds across an eight-cabinet run.

The island

The island was sized to leave adequate clearance on all sides. Forty-two inches minimum between the cabinet face and the island edge allows two people to pass each other while working without conflict. The overhang on the living room side is twelve inches, enough for bar stools at a comfortable seated height without the island feeling like a counter with chairs pushed against it. The proportions matter here. An island that is too large for the kitchen makes the room harder to work in. This one was sized to what the space could correctly accommodate.

The island base used the same navy finish as the lower perimeter cabinets, which ties it to the kitchen rather than making it feel like a furniture piece that was added after the fact. The countertop material continued across both the island and the perimeter countertops. When the two surfaces match, the kitchen reads as a complete design. When they differ, the island draws attention to itself rather than to the room.

Backsplash, hardware, and appliances

The backsplash is white subway tile in a standard running bond pattern, installed from the counter up to the bottom of the upper cabinets. Grout color is a light warm gray, which gives definition to the tile joints without creating high contrast that competes with the navy cabinets. Running the backsplash full height behind the range created a clean focal point at the cooking position and avoided the awkward transition between partial backsplash and painted drywall that shows up in many kitchen updates.

Hardware throughout is brushed nickel in a simple bar pull profile. Hardware is one of the few places in a kitchen where cost has no real relationship to the visual outcome. The right profile in the right finish, installed consistently across every door and drawer, reads better than expensive hardware that fights with the cabinet style. The brushed nickel coordinates with the stainless appliances and the stainless range hood without requiring an exact match between the two metals.

The stainless appliances and the range hood bring all the metal finishes into alignment. The hood is a statement piece above the range and it draws the eye up from the navy cabinets to the white tile and then to the hood itself, which is the correct hierarchy in a kitchen where cooking is a central activity. Getting the rough-in height right on the hood installation, and getting the liner properly ducted to the exterior rather than recirculating, was part of the rough work scope before the cabinets went in.

The hardwood floors

The hardwood floor was the decision that made this project larger than a kitchen renovation. The existing kitchen had vinyl. The living area adjacent to it had carpet. Both were being replaced, and the question was whether to use different materials in the two spaces or run a single material through both. Running hardwood from the kitchen through the full living area was the right call. It is a larger upfront investment, but it produces a fundamentally different spatial outcome than two separate flooring materials with a transition strip between them.

The species is a warm-toned oak in a natural finish. Warm-toned hardwood with a natural oil finish coordinates with the navy cabinets and the white tile without competing with either. The boards are three and a quarter inches wide, which is appropriate for the room size. Wider boards in a smaller space emphasize the floor in a way that pulls attention away from everything else. Narrower boards in a larger space look busy. Three and a quarter works here because the proportions of the room support it.

Hardwood installation starts with the subfloor. Any squeaks, high spots, or soft areas need to be addressed before the finish floor goes down. Squeaks in hardwood are almost always a subfloor issue, not a finish floor issue, and they cannot be fixed without removing the finished floor to get back to the substrate. The subfloor in this project was inspected thoroughly, and the few areas that had movement were face-screwed before the hardwood installation began. A properly prepared subfloor is invisible in the result, which is exactly the point.

The board direction runs parallel to the longest wall in the house, which makes the living area feel longer and draws the eye toward the primary window view at the far end. The boards run continuously from the kitchen through the living area without a transition strip, which is what makes the floor read as one cohesive surface rather than two rooms with matching flooring. Getting the continuous run to work required careful planning of the starting layout so that the board width at both the kitchen wall and the far living room wall is consistent.

The result

The kitchen delivers what the homeowners wanted: a room where you can cook, gather, and move around without the layout working against you. The island gives prep space and a place for people to sit without being in the work zone. The finishes are current without being fragile in the way that very trendy kitchens become dated. The navy cabinets are going to look good for a long time.

The floor is what ties the whole main level together. Walking into the house, the eye follows the hardwood from the entry through the kitchen and into the living area as a single connected space. That was the goal from the beginning of the project. It took longer and cost more than two separate flooring scopes would have. The result justifies both.

Licensed in Idaho (RCE# 43451) and Oregon (CCB# 205935). For a kitchen renovation or flooring project in Boise or the Treasure Valley, call or text Christian at (503) 354-4094.

The story behind this project

  1. 1

    Before

    Original kitchen with dated cabinets, outdated countertops, and vinyl flooring throughout the main level. Functional but disconnected from the rest of the home.

  2. 2

    Demo

    Full cabinet and countertop demo. Flooring removed down to subfloor across the kitchen and living area. Plumbing and electrical assessed and updated.

  3. 3

    Floors first

    Hardwood flooring installed across the full main level before any cabinetry went in. Running floors through first ensures clean transitions and no gaps at cabinet bases.

  4. 4

    Cabinets and tile

    Navy lower cabinets and white upper cabinets installed. Island built in place. Subway tile backsplash set from countertop to the bottom of the upper cabinets.

  5. 5

    After

    Stainless appliances set, range hood hung, hardware installed throughout. A complete transformation that made the entire main level feel like a new home.

Project gallery

Full kitchen view with navy and white cabinet combination and stainless appliances

Navy and white cabinet combination

Open-concept dining and living area with warm-tone hardwood floors

Hardwood floors through the open layout